[이현머신과 짜맞춤] 삼방 제비촉 연귀짜임 3rd Joints-WoodroLeehyun 우드로이현 짜맞춤amazing leehyun machine[Eng Sub]

[이현머신과 짜맞춤] 삼방 제비촉 연귀짜임 3rd Joints-WoodroLeehyun 우드로이현 짜맞춤amazing leehyun machine[Eng Sub]


Hello. I’m Lee Hyun-Jin from Woodro Leehyun. This is the 3rd video of joints. I’m going to show you 2 joints, Miter Pointed Joint and 3-way Interlocking Miter Corner Joint. At first, I’m going to rip the walnut lumber with milling sled and then plane the thick. Leehyun Multiwoodmachine is getting upgraded, one by one. Laser line and Milling sled equipped While making the two joints, I’m going to set the stopwatch for working time. Let’s get into it. Well. How was it for you? It’s hard to work by hand. It’s done on the machine with the stopwatch on. For working 3-way Miter Corner Joint like this, It needs10 minutes if the jig is ready. I’m going to show you a few of level-up videos about joints. After it, I’ll be working from a frame to furniture using joints. If you enjoyed watching this video, don’t forget to hit the likes or subscription button. Thanks a lot for watching and see you next. Woodro Leehyun Inc. Woodro Leehyun : Facebook & Instagram
[email protected]

12 thoughts on “[이현머신과 짜맞춤] 삼방 제비촉 연귀짜임 3rd Joints-WoodroLeehyun 우드로이현 짜맞춤amazing leehyun machine[Eng Sub]”

  1. 참 웃기다..
    저걸 왜 시간을 재는지?
    뭐..빠르다는 소린가?
    그렇게 따지면..그냥 톱질 과 끌질이 더 빠르고
    또 .. 왜 가공 시간만 재는지?
    셋팅 하고 지그 만들고 자리 잡고 하면..으구~~!! 세월 다 가근네~~!!
    그냥 톱질 하고 끌질이면 끝나는건데
    참 어럽게한다~~!!
    가공하다..삑싸리 치면..그냥 제비쪽..요단강 건너가겠구만..~~~!

  2. 시간별 가이드 입니다 🙂
    3:37 1차 타이머 시작
    15:50 1차 타이머 종료
    16:29 2차 타이머 시작
    23:09 2차 타이머 종료
    23:46 3차 타이머 시작
    41:57 3차 타이머 종료

Leave a Reply

Your email address will not be published. Required fields are marked *